Parkside PGG 15 A1 Manual do Utilizador descarregar pdf (Página 14)

14 GB

Operation

Switching on:

Press the ON / OFF switch

Switching off:

Release the ON / OFF switch

Setting the stroke rate

The stroke switch

is used to set the penetration depth of the engrav-

ing. A low setting is normally adequate for most engraving tasks.

Turn the switch for the number of strokes

in the + direction to

increase the penetration depth.

Turn the switch for the number of strokes

in the – direction to

decrease the penetration depth.

Note: Take care when increasing the penetration depth that you do

not turn the stroke switch

too far in the + direction. Otherwise the

switch could screw oﬀ the device.

Changing the engraving point

RISK OF INJURY! Switch the device oﬀ before

performing any tasks on the device and pull the mains plug out of the

mains socket.

Replace the engraving point

as soon as it becomes too worn

and no longer provides the desired engraving performance. Turn

the engraving point holder

anticlockwise until the engraving

point

is released.

66133_Mini-Graviergerät_content_LB4.indd 14 03.06.11 16:59

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 114 115

Sem comentários

Parkside PGG 15 A1 Manual do Utilizador Página 14